T-Rex 450 PRO TT Clone
Geplaatst: 05 Mei 2012, 16:58
Ik sta op het punt om te beginnen met de bouw van mijn 450 PRO CLONE, dus toch maar even op de gevoelige plaat zetten...
Volledige Setup :
- Clone Kit
- Witte carbon Blades
- Witte carbon paddles
- Witte carbon tailblades
- Wit landingsgestel
- Turnigy Canopy
- Spectrum AR8000
- Align 430XL Motor
- KDS 40A ESC
- 3 x MG90 servo's op de swash
- 1 x KDS N590 op de staart
- KDS 800 Gyro
- Zippy 3S 2200 Lipo
Als hulpje gebruik ik de handleiding van de originele Align 450 PRO.
DOWNLOAD HANDLEIDING
Mvg,
RSSD
UPDATE :
Landingsgestel
Staart + staartbuis
Verticale stabilisatievin. (voorlopig gemonteerd, stukje te kort)
Staart servo KDS
Align motor
ESC
Servo's
Gyro KDS
Spectrum ontvanger
Ontvanger satteliet
Aansluitingen
Rotor Threadlocked
XT60 connector + lipobevestiging
Stukje voor de staart is ook binnen.
Staartblades
Volledige Setup :
- Clone Kit
- Witte carbon Blades
- Witte carbon paddles
- Witte carbon tailblades
- Wit landingsgestel
- Turnigy Canopy
- Spectrum AR8000
- Align 430XL Motor
- KDS 40A ESC
- 3 x MG90 servo's op de swash
- 1 x KDS N590 op de staart
- KDS 800 Gyro
- Zippy 3S 2200 Lipo
Als hulpje gebruik ik de handleiding van de originele Align 450 PRO.
DOWNLOAD HANDLEIDING
Mvg,
RSSD
UPDATE :
Landingsgestel
Staart + staartbuis
Verticale stabilisatievin. (voorlopig gemonteerd, stukje te kort)
Staart servo KDS
Align motor
ESC
Servo's
Gyro KDS
Spectrum ontvanger
Ontvanger satteliet
Aansluitingen
Rotor Threadlocked
XT60 connector + lipobevestiging
Stukje voor de staart is ook binnen.
Staartblades